Experiment Name: -Study on the climax dobby mechanism.
1. To know about the different parts formed this shedding.
2. To learn the mechanism of dobby shedding.
A&B = Jack lever
Dobby loom is important for its use. We can use 8-12 heald frames in tappet loom but if we want to use more heald frame for more decorative design then we should use dobby loom. This practical helps me to know about the dobby loom and its mechanism. I think this will helpful to build our future life.
Introduction:
Dobby
is a shedding mechanism placed
on the top of the loom in order to produce figured patterns by using large
number of healds than the capacity of a tappet. Dobby is also known as a “witch
or “wizard”.
Objectives:
1. To know about the different parts formed this shedding.
2. To learn the mechanism of dobby shedding.
Scope of a dobby:
The
scope of dobby is limited between a tappet and a jacquard. The number of shafts
that can be actuated by a dobby varies between 6 and 40. Theoretically dobby
can control 48 shafts (maximum). However, practically it can control 36 shafts
in case of wool and allied fibers. Again, for cotton and allied fibers, it can
control maximum 24 heald shafts. In these case healds are operated by jacks and
levers.
Main parts:
A&B = Jack lever
C =Link
D&E =Knife
H&I =Fulcrum
J =Baulk lever
P&Q =Hook
R = Up right connect
S = Bottom shaft
T&L = lever
Y&Z = Feelers
Fig: Climax
Dobby shedding mechanism
Climax Dobby shedding mechanism:
Here a climax dobby is described to explain the dobby
shedding mechanism. Climax dobby is a double lift double jack-lever negative
dobby. Here two jack levers are operated by a single bulk lever. They are
joined with the bulk lever by a timber lever and a link. The double lever is
fulcrum med at a point and is connected with S-lever.
The S-lever controls two hooks, one upper hook and one lower hook. The hooks are controlled by feelers. One hook is controlled by hooked feeler and other by a connecting needle. The two hooks control two knives that are joined with a T-lever.
The T-lever is fulcrum med and is controlled by an upright shaft and an L-lever. They get motion from motor and machine pulley. When the feeler comes in contact with a peg and when it is not in the contact it goes down.
Conclusion:
The S-lever controls two hooks, one upper hook and one lower hook. The hooks are controlled by feelers. One hook is controlled by hooked feeler and other by a connecting needle. The two hooks control two knives that are joined with a T-lever.
The T-lever is fulcrum med and is controlled by an upright shaft and an L-lever. They get motion from motor and machine pulley. When the feeler comes in contact with a peg and when it is not in the contact it goes down.
Conclusion:
Dobby loom is important for its use. We can use 8-12 heald frames in tappet loom but if we want to use more heald frame for more decorative design then we should use dobby loom. This practical helps me to know about the dobby loom and its mechanism. I think this will helpful to build our future life.
No comments:
Post a Comment